Publication Index

An independent archive of publications and research works.

Showing 2 publications
RR-2026-0729 • 2026 • Physics technical report

Modelling the Doppler Effect and Mach Cone Formation

Ruben David Roy
The Doppler effect is the apparent change in a wave’s observed frequency caused by relative motion between its source and an observer. This report focuses on sound emitted by a moving source and detected by a stationary observer in a stationary medium, and investigates how the relationship between a supersonic aircraft’s velocity and the local speed of sound dictates the formation of a Mach cone. An interactive digital simulation was created as a learning tool for Year 11 Physics students. Users can vary source speed, wave speed, and emitted frequency continuously and immediately see changes in compression, rarefaction, observed frequency and Mach cone geometry. The model allows experimentation across subsonic, sonic and supersonic conditions, whilst its quantitative readout calculates the source velocity, Mach number and observed frequencies. Although the simulation depicts 2D kinematics effectively, it is restricted to a two-dimensional planar surface and assumes a homogeneous atmosphere. Future versions could add an opacity gradient to approximate intensity attenuation under the Inverse Square Law and a vertical temperature gradient to simulate atmospheric refraction. Nevertheless, the model remains effective because its numerical feedback and interactivity help students connect abstract Doppler-effect equations to observable wavefront behaviour.
Physics Wave Mechanics Computational Modelling
RR-2026-0618 • 2026 • Technical design report

Engineering an E-Waste PPG Heart-Rate Monitor

Ruben David Roy
This project aimed to respond to two problems found in modern work and study environments: the growth of electronic waste and the separation of users from their natural biological rhythms. A tabletop photoplethysmographic (PPG) heart-rate monitor was engineered from discarded and unused components, including a Raspberry Pi 3B+, LCD screen, webcam module, power bank, SD card, cabling, case parts, and a silicone finger mesh. The device used a dedicated LED and camera to detect small changes in reflected light from the finger. A Python program processed these changes, calculated beats per minute, and displayed a live cardiovascular waveform through Pygame. Development was divided into concurrent software, hardware, and documentation workflows. Three internal chassis versions and two housing versions were produced. Changes were made after cable tension twisted the internal components, printed supports snapped or blocked ports, the camera sat at the wrong height, an LED shut off under bright light, and movement created unstable readings. The final design used a six-pillar chassis, a removable lid, a flexible finger interface, and a Voronoi-textured enclosure. Five preliminary comparisons were completed against a commercial fingertip pulse oximeter. The prototype remained within one beat per minute of the reference readings under the stationary conditions tested. The result was a functioning PPG heart-rate monitor made mainly from reclaimed components.
Engineering Design Embedded Systems Sustainable Design